Perplexed by all this talk of u-values and blower door tests? Our sustainable building glossary will help you get to grips with the key terminology.
This is a wall shared between two properties. Coincidentally, in buildings with poor acoustic properties it can be the focus of much tension when neighbours throw parties
|Passive House Planning Package||
A software programme developed by the Passive House Institute that's used to design and test buildings aiming to meet the passive house standard. It's often used as a design tool for low energy buildings even if the architect or builder is not specifically aiming to meet the standard
|Passive House Plus standard||
The ‘passive house plus’ standard is a new certification category designed to recognise the production of onsite renewable energy by passive buildings. It requires a minimum of 60k kWh/m2/yr of renewable energy generation, along with a maximum renewable primary (PER) energy demand of 45 kWh/m2/yr. PER is a new energy factor developed by the Passive House Institute designed for a future where electricity grids are powered entirely by renewables. It is designed to replace traditional primary energy demand in the long term. In this case, a higher PER demand, 56 kWh/m2/yr, was allowed because the dwelling produces much more (83 kWh/m2/yr) than the renewable energy generation target.
The even more advanced ‘passive house premium’ standard requires generation of 120 kWh/m2/yr and a maximum PER of 30 kWh/m2/yr. Meanwhile under this new system, the traditional passive house standard is rebranded as ‘passive house classic’, and has a max PER of 60 kWh/m2/yr, with no renewable generation required.
This new classification system is operational alongside the traditional passive house standard, with its maximum primary energy demand of 120 kWh/m2/yr, and no requirement for renewable energy production. The targets for space heating demand (15 kWh/m2/yr) and heat load (10 W/m2) remain the same under both certification systems.
|PEFC certified wood||
Like the FSC, the Programme for the Endorsement of Forest Certification certifies forests that are managed sustainably
The difference between how a building is designed to perform and how it subsequently does in reality once built. The term usually refers to energy consumption but can refer to other aspects of building performance too
A technology that uses energy from the sun to produce electricity
A type of masonry block with a lower embodied energy than traditional concrete, made from clay that is heated to about 1000C. Also known as teracotta block
This is the 'linear thermal transmittance', the rate of heat flow per degree temperature difference per unit length of a thermal bridge. It is measured in W/mK, and is used to calculate the heat loss or gain through a thermal bridge. Under Irish and UK building regulations, the Psi-values for all non-repeating thermal bridges are multiplied by the measured length of each bridge before a Y-value for the building can be calculated, expressed in W/m2K.